EnglishViews: 1 Author: Site Editor Publish Time: 2026-10-14 Origin: Site
An AI forklift anti-collision camera system with automatic braking is a retrofit safety device that watches the blind zones around a truck with a vision camera and intervenes before contact happens. This system protects in three stages: at 6 m it gives the driver a voice alert, at 3 m it forces the vehicle to slow down, and at 2 m it applies automatic braking. Rated at a vehicle speed of 8 km/h with a person detected, the braking distance is within 2 m, and the system response time (detection to alert) is ≤ 1 second. The housing is rated IP66 for outdoor yards, rain and dust. It fits forklifts and all construction vehicles, ships in 5 working days, with a minimum order of 1 set at US$3,600 per set (EXW).
An AI forklift anti-collision camera system is a camera-based safety device that detects pedestrians, other vehicles and obstacles around a forklift or construction vehicle, warns the operator, and — in systems with automatic braking — intervenes in the vehicle's motion when a person enters a defined danger zone.
It replaces three weaker layers of protection that most sites rely on today: mirrors that cannot see around a rack end, audible reversing beepers that operators habituate to and stop registering, and the assumption that the pedestrian and the driver will both see each other in time. A camera-based system does not depend on either person noticing anything.
Because detection is camera-based, pedestrians carry nothing. There are no tags, lanyards, vests or batteries to issue, charge, replace or enforce — which is the practical reason this category is chosen over tag-based proximity systems on sites with visitors, contractors and mixed pedestrian traffic.
Three-stage protection means the system does not wait until the last moment to act. Each stage buys time for the next one.
Stage | Distance | What the system does | What it changes on site |
|---|---|---|---|
Stage 1 | 6 m | Voice alert to the operator | The driver is warned while there is still time to act |
Stage 2 | 3 m | Speed limiting — the vehicle is forced to slow down | The remaining stopping distance is cut before braking is even needed |
Stage 3 | 2 m | Automatic braking | The truck is stopped even if the operator does not respond |
The engineering logic is that each stage reduces the energy left in the system. By the time the vehicle reaches the 2 m braking line it has already been decelerating since 3 m, which is why the braking performance quoted below is realistic at a real working speed rather than only on paper.
These are three separate figures, and conflating them is the most common spec error in this product category:
Metric | What it measures | Value |
|---|---|---|
Detection-to-alert latency | Time for the system to identify a target and raise the alert | ≤ 1 s |
Braking trigger distance | Distance at which the system applies the brakes | 2 m |
Braking distance | Distance from brake application to a full stop, rated at 8 km/h with a person detected | within 2 m |
Two questions follow from this, and both have concrete answers.
“At 8 km/h, doesn't a 1-second response already consume 2 m?”
8 km/h is approximately 2.22 m/s, so a one-second latency does correspond to roughly 2.2 m of travel. That is exactly what the three-stage design absorbs. The vehicle receives the voice alert at 6 m and is force-limited at 3 m, so it is already below 8 km/h by the time it reaches the 2 m braking line. The quoted braking distance is achieved from that reduced speed. Read as a chain — alert at 6 m, speed limit at 3 m, brake at 2 m — the figures are consistent.
“Is the braking distance a best case or a guaranteed figure?”
It is stated at a defined rated condition: a vehicle speed of 8 km/h with a person detected. That is the number to compare when evaluating systems. A stopping figure quoted without a stated speed is not a specification.
Vehicles: forklifts, reach trucks, pallet trucks and order pickers, plus construction vehicles including excavators, wheel loaders, dump trucks and telehandlers. The system is designed for low-speed operation up to 8 km/h.
Sites: warehouse aisles, loading docks, container yards, ports, construction sites, and any location where pedestrians and trucks share the same traffic path — blind corners, aisle intersections, crossing points, reversing zones, night shifts and outdoor yards.
Environment: the IP66 housing is rated for outdoor use, rain, dust and washdown conditions.
The three approaches differ first in what they require of the person being protected. This is the structural difference; performance varies by vendor, so always request the rated figures for each.
Approach | What the pedestrian must carry | Detection basis |
|---|---|---|
Tag / UWB-based proximity | A tag, usually on a lanyard or in a pocket | Radio signal between tag and vehicle |
Radar-based detection | Nothing | Radio reflection from objects in the detection field |
AI camera-based (this system) | Nothing | Vision camera with on-device AI classification |
On sites with visitors, contractors, drivers from other companies and temporary staff, the tag-based model fails at the enforcement step: if the tag is not carried, protection does not exist. A camera-based system has no such dependency, and additionally classifies what it sees rather than only detecting that something is there.
Item | Value |
|---|---|
Voice alert distance | 6 m |
Speed limiting distance | 3 m |
Automatic braking distance | 2 m |
Braking distance (person detected, 8 km/h) | within 2 m |
Operating speed | up to 8 km/h |
System response time (detection to alert) | ≤ 1 s |
Protection rating | IP66 |
Vehicle compatibility | Forklifts + all construction vehicles |
Minimum order quantity | 1 set |
Lead time | 5 working days |
Price | US$3,600 / set (EXW) |
Work through these six steps before you buy, whichever system you choose:
Map your conflict points. List every place in your site where a pedestrian and a truck share the same path — rack ends, aisle intersections, dock doors, crossing points. These are the zones that need coverage, not the whole building.
Record your vehicle types and their working speeds. A system rated at 8 km/h needs to be matched against the speeds your trucks actually reach in those zones.
Confirm the stopping figures and the condition they are rated at. Ask for braking distance at a stated speed, with a person detected. If the speed is not stated, the figure cannot be evaluated.
Decide the intervention behaviour. Voice alert only, alert plus speed limiting, or full automatic braking. Speed limiting and braking require integration with the vehicle's control system, so confirm this with the truck's make and model.
Trial on one truck first. A single-unit trial on your worst conflict point will tell you more than any datasheet — which is why a minimum order of one set matters for buyers running a pilot.
Roll out, then review. Once deployed, revisit your incident and near-miss data at 90 days to confirm the zones you selected are the ones that needed coverage.
A camera-based safety system that detects pedestrians, vehicles and obstacles around a forklift or construction vehicle, warns the operator, limits vehicle speed and applies automatic braking. Detection uses a vision camera with on-device AI classification.
A voice alert at 6 m, forced speed limiting at 3 m, and automatic braking at 2 m. Because each stage reduces the vehicle's energy, the truck is already slowing before it reaches the braking line.
Rated at a vehicle speed of 8 km/h with a person detected, the braking distance is within 2 m. The system response time from detection to alert is ≤ 1 second. These are separate metrics: one is a distance under braking, the other is a detection latency.
No. Detection is camera-based, so pedestrians carry nothing. This is what makes it workable on sites with visitors, contractors and temporary staff.
Yes. The housing is rated IP66, suitable for outdoor yards, rain and dusty environments.
Forklifts, reach trucks, pallet trucks and order pickers, plus construction vehicles including excavators, wheel loaders, dump trucks and telehandlers. Send your vehicle brand and model to confirm fitment.
US$3,600 per set (EXW), minimum order 1 set, lead time 5 working days. Send your vehicle type and destination country and we will quote including a freight indication.
Yes. The minimum order quantity is one set, which is intended for exactly this — pilot on your highest-risk conflict point before committing the fleet.
Send us your vehicle brand and model, the number of units and your destination country, and we will confirm fitment and send the datasheet, the quotation and a freight indication within 24 hours.
Price: US$3,600 per set (EXW) · MOQ: 1 set · Lead time: 5 working days
Sabo Forklift AI Anti Collision System: at level 1, AI camera detected pedestrains, it gets alert alarm. at level 2, when pedestrains keep going forward to forklift, it starts speed slow. at level 3, when pedestrains still going forwarder to forklift, it gets auto-brake.
Background: Factory C has a blind spot in the safety management of forklift trucks, and speeding occurs from time to time, which poses a safety hazard to the factory's production.
Bearing Co., Ltd, forklift driver Guo Mou in the delivery of iron chips hopper, due to the height of the hopper beyond the range of vision, resulting in the inability to see clearly the situation ahead, accidentally knocked down the same direction with the push bucket truck to transport iron chips employee Hua Mou, Hua Mou after rescue and died. This accident directly exposed the safety risk of forklifts in the case of line-of-sight obstruction.
Zhuhai Gree Electric Appliances Co., Ltd. was founded in 1991 and listed in November 1996 on the Shenzhen Stock Exchange. At the early stage of its establishment, the company mainly relied on the assembly and production of household air-conditioners, and has now developed into a diversified, technology-based global industrial manufacturing group, with industries covering the two major fields of household consumer goods and industrial equipment, and its products are exported to more than 190 countries and regions. Its forklift trucks are mainly used in production workshops, inside and outside warehouses and factory parks, etc., and the equipment they carry is mainly large home appliances such as air conditioners, refrigerators and freezers.
LET 2024 was successfully held from May 29th to May 31st in Area D of Guangzhou Canton Fair Complex. The exhibition focuses on production line logistics automation, warehousing and logistics intelligence, supply chain logistics, digital factory and intelligent manufacturing, focusing on digital factory planning and equipment, intralogistics system, intelligent loading and unloading, AGV & AMR, manipulator, conveyor system, new energy forklift trucks and accessories, packaging system, informatization & industrial Internet of Things, sensors, pallets, fresh supply chain and equipment technology, and other cutting-edge products, technologies and industry solutions. product technology and industry solutions.